GHSA-FWVG-QQFX-4M7G
Vulnerability from github – Published: 2026-11-13 03:32 – Updated: 2026-11-13 03:32MCUboot's serial-recovery image-upload handler bs_upload() in boot/boot_serial/src/boot_serial.c declares const struct flash_area *fap = NULL and assigns it only via flash_area_open() part-way through the function. Two early validation failures (goto out_invalid_data) — a CBOR map that fails to decode, or an upload packet missing the off/data members — branch past the open while fap is still NULL, then fall into the shared epilogue. In MCUBOOT_ENC_IMAGES builds that epilogue unconditionally calls boot_handle_enc_fw(fap), which reaches boot_image_load_header() and flash_area_read() and dereferences the NULL flash_area.
The defect is reachable pre-authentication: the trigger is the very first serial-recovery upload command carrying a malformed payload. The guarding conditions are default-true on a fresh recovery session — img_num, curr_off and img_size are zero-initialized statics, so curr_off == img_size and the primary-slot test both hold. It requires a non-default build: encrypted images (MCUBOOT_ENC_IMAGES / Zephyr CONFIG_BOOT_ENCRYPT_IMAGE) together with an active serial-recovery transport, on the Zephyr or Mynewt port (the two that build both boot/boot_serial/src/boot_serial.c and boot_serial_encryption.c with MCUBOOT_ENC_IMAGES).
The impact is a transient denial of service of the bootloader during recovery. fap is a hard NULL rather than an attacker-controlled value, so there is no memory-corruption or information-leak primitive and image authentication is unaffected. Whether the dereference faults is platform-dependent — on targets where address 0x0 is mapped readable flash the read merely returns an error and execution continues, while targets that trap NULL (MPU / null-pointer-exception detection) take a hard fault. Because serial recovery is unauthenticated by design and already permits the console attacker to write the secondary slot, the added capability is only a low-value transient crash.
The related unconditional flash_area_close(fap) call in the same epilogue is a safe no-op on the ports that reach it, so it does not contribute to the dereference.
The affected ports are the Zephyr port — boot/zephyr/CMakeLists.txt compiles boot_serial.c under CONFIG_MCUBOOT_SERIAL and boot_serial_encryption.c under CONFIG_BOOT_ENCRYPT_IMAGE — and the Mynewt port, whose mcuboot_config.h defines MCUBOOT_SERIAL unconditionally and MCUBOOT_ENC_IMAGES under any BOOTUTIL_ENCRYPT_ syscfg, with boot/boot_serial/pkg.yml declaring no explicit source list so the whole directory is built. The Espressif port is not affected**: it compiles boot_serial.c but not boot_serial_encryption.c, and defines no MCUBOOT_ENC_IMAGES, so the #ifdef MCUBOOT_ENC_IMAGES block containing the call is preprocessed away. The NuttX, Cypress and Mbed ports do not build boot_serial.c at all.
{
"affected": [],
"aliases": [
"CVE-2026-16659"
],
"database_specific": {
"cwe_ids": [
"CWE-476"
],
"github_reviewed": false,
"github_reviewed_at": null,
"nvd_published_at": "2026-11-13T02:18:56Z",
"severity": "MODERATE"
},
"details": "MCUboot\u0027s serial-recovery image-upload handler bs_upload() in boot/boot_serial/src/boot_serial.c declares const struct flash_area *fap = NULL and assigns it only via flash_area_open() part-way through the function. Two early validation failures (goto out_invalid_data) \u2014 a CBOR map that fails to decode, or an upload packet missing the off/data members \u2014 branch past the open while fap is still NULL, then fall into the shared epilogue. In MCUBOOT_ENC_IMAGES builds that epilogue unconditionally calls boot_handle_enc_fw(fap), which reaches boot_image_load_header() and flash_area_read() and dereferences the NULL flash_area.\n\nThe defect is reachable pre-authentication: the trigger is the very first serial-recovery upload command carrying a malformed payload. The guarding conditions are default-true on a fresh recovery session \u2014 img_num, curr_off and img_size are zero-initialized statics, so curr_off == img_size and the primary-slot test both hold. It requires a non-default build: encrypted images (MCUBOOT_ENC_IMAGES / Zephyr CONFIG_BOOT_ENCRYPT_IMAGE) together with an active serial-recovery transport, on the Zephyr or Mynewt port (the two that build both boot/boot_serial/src/boot_serial.c and boot_serial_encryption.c with MCUBOOT_ENC_IMAGES).\n\nThe impact is a transient denial of service of the bootloader during recovery. fap is a hard NULL rather than an attacker-controlled value, so there is no memory-corruption or information-leak primitive and image authentication is unaffected. Whether the dereference faults is platform-dependent \u2014 on targets where address 0x0 is mapped readable flash the read merely returns an error and execution continues, while targets that trap NULL (MPU / null-pointer-exception detection) take a hard fault. Because serial recovery is unauthenticated by design and already permits the console attacker to write the secondary slot, the added capability is only a low-value transient crash.\n\nThe related unconditional flash_area_close(fap) call in the same epilogue is a safe no-op on the ports that reach it, so it does not contribute to the dereference.\n\nThe affected ports are the Zephyr port \u2014 boot/zephyr/CMakeLists.txt compiles boot_serial.c under CONFIG_MCUBOOT_SERIAL and boot_serial_encryption.c under CONFIG_BOOT_ENCRYPT_IMAGE \u2014 and the Mynewt port, whose mcuboot_config.h defines MCUBOOT_SERIAL unconditionally and MCUBOOT_ENC_IMAGES under any BOOTUTIL_ENCRYPT_ syscfg, with boot/boot_serial/pkg.yml declaring no explicit source list so the whole directory is built. The Espressif port is not affected**: it compiles boot_serial.c but not boot_serial_encryption.c, and defines no MCUBOOT_ENC_IMAGES, so the #ifdef MCUBOOT_ENC_IMAGES block containing the call is preprocessed away. The NuttX, Cypress and Mbed ports do not build boot_serial.c at all.",
"id": "GHSA-fwvg-qqfx-4m7g",
"modified": "2026-11-13T03:32:01Z",
"published": "2026-11-13T03:32:01Z",
"references": [
{
"type": "WEB",
"url": "https://github.com/mcu-tools/mcuboot/security/advisories/GHSA-777r-3chm-p78c"
},
{
"type": "ADVISORY",
"url": "https://nvd.nist.gov/vuln/detail/CVE-2026-16659"
},
{
"type": "WEB",
"url": "https://github.com/mcu-tools/mcuboot/commit/400f9a7242641655948b08acac19932f56d9881f"
}
],
"schema_version": "1.4.0",
"severity": [
{
"score": "CVSS:3.1/AV:L/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:L",
"type": "CVSS_V3"
}
]
}
Drag nodes to arrange them. Double-click a related vulnerability to open it, or a source to visit its link. The Physics button on the left tunes the layout and the simulation; the legend at the bottom left hides or shows nodes by kind and by sighting type.
Sightings
| Author | Source | Type | Date | Other |
|---|
Nomenclature
- Seen: The vulnerability was mentioned, discussed, or observed by the user.
- Confirmed: The vulnerability has been validated from an analyst's perspective.
- Published Proof of Concept: A public proof of concept is available for this vulnerability.
- Exploited: The vulnerability was observed as exploited by the user who reported the sighting.
- Patched: The vulnerability was observed as successfully patched by the user who reported the sighting.
- Not exploited: The vulnerability was not observed as exploited by the user who reported the sighting.
- Not confirmed: The user expressed doubt about the validity of the vulnerability.
- Not patched: The vulnerability was not observed as successfully patched by the user who reported the sighting.
Vulnerability timeline
Sightings and recorded dates, grouped by day · UTC
How durations are calculated
Following the VTEM framework (Black Hat USA 2015), time to patch starts when the vendor or a coordinator was informed, total time to patch at discovery, and disclosure to patch at public disclosure; vendor response time runs from the report to its acknowledgement. Time to exploit and time unpatched start at the earliest discovery or report, falling back to public disclosure. Unpatched time ends at the first recorded patch, or the calculation time when no patch is recorded. Exploitation to patch shows the interval between those two events; a published proof of concept is a public exploit, not exploitation.
Each result shows its source dates. A negative interval means the end event came first; when date-only inputs leave the order open, the result says so. Date-only inputs are approximate. The earliest evidence wins: KEV report dates and sightings are labelled as such. Records describing another vulnerability are listed but never calculated from, and a PoC alone does not establish exploitation. Missing patch evidence does not prove that no patch exists. Filters below change the event list only.
Loading timeline…
The approach is described in our paper Mapping CVEs to MITRE ATT&CK Techniques: A Curated Gold-Set Classifier and the Limits of LLM-Assisted Label Expansion.
Browse all ATT&CK techniques and the vulnerabilities related to each.
Related by attack behaviour
Vulnerabilities whose description is nearest to this one in the vector space of the CIRCL/vulnerability-attack-technique-biencoder model. This is a similarity search over the bi-encoder space (plain cosine), not a classification, and it has no measured accuracy.