GHSA-4MP4-CG6Q-QVJW

Vulnerability from github – Published: 2026-11-13 03:32 – Updated: 2026-11-13 03:32
VLAI
Details

MCUboot's Zephyr serial-recovery upload handler bs_upload() in boot/boot_serial/src/boot_serial.c decodes the host-supplied image field of an MCUmgr image-upload request into img_num (a full 32-bit value) and latches it on the off == 0 packet without any range check. It then passes img_num straight to flash_area_id_from_multi_image_slot(img_num, 0), which on the Zephyr port resolves to __flash_area_ids_for_slot() in boot/zephyr/include/sysflash/sysflash.h and indexes the static const int all_slots[] table as all_slots[img_num 2]. That table holds only MCUBOOT_IMAGE_NUMBER 2 entries, so any img_num >= MCUBOOT_IMAGE_NUMBER is an out-of-bounds read.

The path is reachable by anyone with access to the serial / SMP recovery console, which is unauthenticated by design, and the bad value is supplied before any image signature is verified. The defect is specific to the default non-direct upload path (MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD disabled) on the Zephyr port with the array-backed slot layout (not CONFIG_SINGLE_APPLICATION_SLOT). It is not gated on a multi-image configuration: MCUBOOT_IMAGE_NUMBER defaults to 1, so even a default single-image build is affected for any image >= 1. The MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD path is safe (its flash_area_id_from_direct_image() switch returns -EINVAL for unknown indices).

flash_area_id_from_multi_image_slot() takes a signed int image_index while img_num is uint32_t, so the attacker controls the sign of the index as well as its magnitude: an image of 0xFFFFFFFF converts to -1 and reads all_slots[-2], off the front of the table, while large positive values read off the end (CWE-192). Either way the index multiply img * 2 is performed in int, so a wild offset yields a bus/hard fault, giving a reliable denial of service of the bootloader during recovery. For moderately out-of-range indices the read returns adjacent .rodata as a garbage flash-area id that is handed to flash_area_open(); this normally fails with MGMT_ERR_EINVAL, but if the garbage id happens to match a valid non-image partition, the subsequent erase/write can target a partition outside the image set (CWE-787). The attacker-supplied value is never echoed back, so there is no information disclosure. The fix is to reject img_num >= BOOT_IMAGE_NUMBER on the off == 0 packet, before the slot lookup. The comparison must be made on the unsigned img_num: an equivalent guard applied after the conversion to int would not reject the negative case above. __flash_area_ids_for_slot() should bounds-check its own arguments as defence in depth. This vulnerability was reported independently twice: by NVIDIA Project Vanessa on 2026-06-22, and by Kai Phan (@kaimandalic) on 2026-07-19 as GHSA-8v33-88p6-jffj, which is closed as a duplicate of this advisory. Both original reports are reproduced in full below.

Severity
5.1 (Medium)
CVSS:3.1/AV:L/AC:L/PR:N/UI:N/S:U/C:N/I:L/A:L
Show details on source website
To clipboard 

{
  "affected": [],
  "aliases": [
    "CVE-2026-16664"
  ],
  "database_specific": {
    "cwe_ids": [
      "CWE-129"
    ],
    "github_reviewed": false,
    "github_reviewed_at": null,
    "nvd_published_at": "2026-11-13T02:18:57Z",
    "severity": "MODERATE"
  },
  "details": "MCUboot\u0027s Zephyr serial-recovery upload handler bs_upload() in boot/boot_serial/src/boot_serial.c decodes the host-supplied image field of an MCUmgr image-upload request into img_num (a full 32-bit value) and latches it on the off == 0 packet without any range check. It then passes img_num straight to flash_area_id_from_multi_image_slot(img_num, 0), which on the Zephyr port resolves to __flash_area_ids_for_slot() in boot/zephyr/include/sysflash/sysflash.h and indexes the static const int all_slots[] table as all_slots[img_num  2]. That table holds only MCUBOOT_IMAGE_NUMBER  2 entries, so any img_num \u003e= MCUBOOT_IMAGE_NUMBER is an out-of-bounds read.\n\nThe path is reachable by anyone with access to the serial / SMP recovery console, which is unauthenticated by design, and the bad value is supplied before any image signature is verified. The defect is specific to the default non-direct upload path (MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD disabled) on the Zephyr port with the array-backed slot layout (not CONFIG_SINGLE_APPLICATION_SLOT). It is not gated on a multi-image configuration: MCUBOOT_IMAGE_NUMBER defaults to 1, so even a default single-image build is affected for any image \u003e= 1. The MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD path is safe (its flash_area_id_from_direct_image() switch returns -EINVAL for unknown indices).\n\nflash_area_id_from_multi_image_slot() takes a signed int image_index while img_num is uint32_t, so the attacker controls the sign of the index as well as its magnitude: an image of 0xFFFFFFFF converts to -1 and reads all_slots[-2], off the front of the table, while large positive values read off the end (CWE-192). Either way the index multiply img * 2 is performed in int, so a wild offset yields a bus/hard fault, giving a reliable denial of service of the bootloader during recovery. For moderately out-of-range indices the read returns adjacent .rodata as a garbage flash-area id that is handed to flash_area_open(); this normally fails with MGMT_ERR_EINVAL, but if the garbage id happens to match a valid non-image partition, the subsequent erase/write can target a partition outside the image set (CWE-787). The attacker-supplied value is never echoed back, so there is no information disclosure. The fix is to reject img_num \u003e= BOOT_IMAGE_NUMBER on the off == 0 packet, before the slot lookup. The comparison must be made on the unsigned img_num: an equivalent guard applied after the conversion to int would not reject the negative case above. __flash_area_ids_for_slot() should bounds-check its own arguments as defence in depth.\nThis vulnerability was reported independently twice: by NVIDIA Project Vanessa on 2026-06-22, and by Kai Phan (@kaimandalic) on 2026-07-19 as GHSA-8v33-88p6-jffj, which is closed as a duplicate of this advisory. Both original reports are reproduced in full below.",
  "id": "GHSA-4mp4-cg6q-qvjw",
  "modified": "2026-11-13T03:32:02Z",
  "published": "2026-11-13T03:32:02Z",
  "references": [
    {
      "type": "WEB",
      "url": "https://github.com/mcu-tools/mcuboot/security/advisories/GHSA-8rcq-2mgr-fhp8"
    },
    {
      "type": "ADVISORY",
      "url": "https://nvd.nist.gov/vuln/detail/CVE-2026-16664"
    },
    {
      "type": "WEB",
      "url": "https://github.com/mcu-tools/mcuboot/commit/183a05f256bdbbac86edcb048958da59018f814e"
    }
  ],
  "schema_version": "1.4.0",
  "severity": [
    {
      "score": "CVSS:3.1/AV:L/AC:L/PR:N/UI:N/S:U/C:N/I:L/A:L",
      "type": "CVSS_V3"
    }
  ]
}



Log in or create an account to share your comment.




Tags
Taxonomy of the tags.




Drag nodes to arrange them. Double-click a related vulnerability to open it, or a source to visit its link. The Physics button on the left tunes the layout and the simulation; the legend at the bottom left hides or shows nodes by kind and by sighting type.

Forecast uses a logistic model when the trend is rising, or an exponential decay model when the trend is falling. Fitted via linearized least squares.

Sightings

Author Source Type Date Other

Nomenclature

  • Seen: The vulnerability was mentioned, discussed, or observed by the user.
  • Confirmed: The vulnerability has been validated from an analyst's perspective.
  • Published Proof of Concept: A public proof of concept is available for this vulnerability.
  • Exploited: The vulnerability was observed as exploited by the user who reported the sighting.
  • Patched: The vulnerability was observed as successfully patched by the user who reported the sighting.
  • Not exploited: The vulnerability was not observed as exploited by the user who reported the sighting.
  • Not confirmed: The user expressed doubt about the validity of the vulnerability.
  • Not patched: The vulnerability was not observed as successfully patched by the user who reported the sighting.
Vulnerability timeline

Sightings and recorded dates, grouped by day · UTC

JSON
How durations are calculated

Following the VTEM framework (Black Hat USA 2015), time to patch starts when the vendor or a coordinator was informed, total time to patch at discovery, and disclosure to patch at public disclosure; vendor response time runs from the report to its acknowledgement. Time to exploit and time unpatched start at the earliest discovery or report, falling back to public disclosure. Unpatched time ends at the first recorded patch, or the calculation time when no patch is recorded. Exploitation to patch shows the interval between those two events; a published proof of concept is a public exploit, not exploitation.

Each result shows its source dates. A negative interval means the end event came first; when date-only inputs leave the order open, the result says so. Date-only inputs are approximate. The earliest evidence wins: KEV report dates and sightings are labelled as such. Records describing another vulnerability are listed but never calculated from, and a PoC alone does not establish exploitation. Missing patch evidence does not prove that no patch exists. Filters below change the event list only.

Loading timeline…




    Related by attack behaviour

    Vulnerabilities whose description is nearest to this one in the vector space of the CIRCL/vulnerability-attack-technique-biencoder model. This is a similarity search over the bi-encoder space (plain cosine), not a classification, and it has no measured accuracy.