The STM32WBA IEEE 802.15.4 driver in drivers/ieee802154/ieee802154_stm32wba.c computed the packet length of a received frame as pkt_len = rx_frame->length - IEEE802154_FCS_LENGTH without first checking that the radio-reported length could hold an FCS. pkt_len is a uint8_t, so a reported length of 0 or 1 wrapped to 254 or 255. The only bound on the resulting value was __ASSERT_NO_MSG(pkt_len <= CONFIG_NET_BUF_DATA_SIZE), which compiles to nothing in the default production configuration (CONFIG_ASSERT=n).

The length originates in the ST link-layer receive-done metadata (p_metadata->length, stored by stm32wba_802154_receive_done()), and ultimately in the PHY header of a frame received over the air, so it is influenced by any attacker within radio range of the device. Reaching the underflow requires the vendor link layer to surface a frame shorter than the FCS with no error; the driver performed no validation of its own on that value.

When the underflow occurs, stm32wba_802154_rx_thread() calls net_pkt_write(pkt, rx_frame->psdu, pkt_len) with a length of about 254 bytes against a receive buffer that holds at most one PHY packet (IEEE802154_MAX_PHY_PACKET_SIZE, 127 bytes). This reads roughly 128 bytes past the end of the radio receive buffer and copies that adjacent memory into a network packet that is submitted to the networking stack, giving an out-of-bounds read with a potential disclosure of adjacent RAM plus needless oversized packet allocation in the RX thread.

The fix r…